Wiring diagram needed

[wmg2]

Need a wiring diagram for a Snapper rear engine rider with a Tecumseh (model 15019H) engine. Have a wire that is burned off and have no idea where it goes. All I can tell is that it comes from the engine and passes under the carb. Cannot find a wire that it might attach to need help.

 

[EngineMan]

Is it just one wire (single) there are not that many on Tecumseh, it could be the fuel shut-down solenoid, it may not have one fitted but the wire maybe there for it.

 

[wmg2]

Is it just one wire (single) there are not that many on Tecumseh, it could be the fuel shut-down solenoid, it may not have one fitted but the wire maybe there for it.

There is a wire that is connected to the bottom side of the carb. This is one that comes out from under the engine cover on the carb side of the engine, looks like about a 16ga wire. Thought it might have burnt off because it is fairly close to the exhaust pipe. There are no other wires under the panel that are not connected to some thing some where.

 

[EngineMan]

I have had a good look into my file's and I can't find wiring diagram for that model, can you not trace back and see where the wiring is coming from, ie take off the engine cover and have a look..?

 

[EngineMan]

I did find this, and am not too sure if it will help you.

 

[wmg2]

I have had a good look into my file's and I can't find wiring diagram for that model, can you not trace back and see where the wiring is coming from, ie take off the engine cover and have a look..?

The wire goes up under the flywheel of the engine. What I need is where does it attach to from there? As I said there do not seem to be any other wires coming from under the seat area that are not attached to something.

 

[EngineMan]

I do understand you, but if you know where is coming from, (fitted to) that will tell you where its has to fit to (other end)