Export thread

So, the debacle continues!
About to remove the valves on my K141 and have noticed there is a large gap already on the valve clearance even before I lap the valves in. There is no adjustment on this motor, so not quite sureof the way forwards.
Would I be right in thinking when I lap the valves in, because they definitely need it as they suffer from blow through, will the gap decrease?

Sec. 12 of this manual talks about how to grind valves to set clearance. https://www.mymowerparts.com/pdf/Ko...al-K91-K141-K161-K181-K241-K301-K321-K341.pdf

Thanks Rivets, unfortunately this won't open?

It should down load, check you download folder. I’ll stay here for an answer, and if it doesn’t work I’ll send it another way.

Just tried again and it won't open, can you send another way?

Try this website and go under Kohler. https://www.mymowerparts.com/pdf/

Have downloaded the file but still can't open it so must be a problrem my end, I'll have a look as to why I can't open it.
Does it explain how to lap etc?

Yes, it is the full service manual.

Thanks Rivets I'll try to open it. Appreciate you help.

If you can get it and I’ll go to another website, be back later better half is sending me on a service call.

LOL

See if you can open this manual? http://resources.kohler.com/power/kohler/enginesUS/pdf/tp_2379.pdf

Yes I can

OK Rivets can now open using chrome, thanks for your time and help, looks like I need new valves!

Not a problem, let us know when you get it running.