Export thread

In 2012, I converted a Swisher fence weedeater, by adding a starter. I had help here getting me the part numbers I needed. It has worked well since then.

Now, the starter spins, put will not kick the gear up all the way to engage. I seem to remember reading not to use any lube on the gear drive.

What will be the best thing to clean and lube the drive, or should I just replace the drive. If I should replace, anybody know the pt # for the drive?

It is a Briggs, 6.75 Intek. The model of the engine is a 120602-0119-E1-06033-FA, and it is a 695550 starter.

Thanks

Rivets,

You helped me build this thing last time. No ideas for help this time around?....

http://www.lawnmowerforum.com/small...0197-b-s-intek-6-75-add-electric-starter.html


http://www.lawnmowerforum.com/small...75-add-electric-starter-redesigned-rebui.html

Briggs says you can use a dry silicone spray to lube the drive system on your starter. A soft bristle brush would be fine for cleaning any dust or debris from the drive system.

Thanks for the help....

Just wanted to be sure I did not make it worse......

My Daddy always told me "It's a wise man who will admit when he does not know something."

This site should be of help getting any part numbers you need. Sound to me like you may need a new bendix drive.

Briggs and Stratton 120602-0119-B1 Parts Diagrams for Blower Housing/Shroud, Electric Starter, Flywheel Group, Rewind Starter

Thanks Rivets, good to talk with you again....:thumbsup: