Looking to make a striping kit for my RER (331416KVE 14H Kohler Series 16)
It appears that you could manufacture something to attach to the rear pipe bumper with minimal invasion. The mower actually does a decent job of pseudo-striping due to the fact that the deck sits quite low, even at its highest setting. You can achieve some pretty decent grass blade bend. Certainly not like I'd like to stripe....
I've been able to pull this off on my Troy-Built push mower. A few cuts of PVC loaded with sand and gravel, and bolted onto the debris guard on the rear of the mower. Works like a dream.
I was hoping that someone could offer an idea for the Snapper.....
