Export thread

repower

#1

J

john higginbotham

hey everybody!
I purchased a used 2166 had blown kholer. had 16 hp briggs on an old cadet. are the engine mount holes the same? I used the longer drive shaft from the briggs factory install, but it seems to be a bit short. any suggestions other than slotting the engine mount holes???
thanks in advance, john


#2

J

john higginbotham

john higginbotham said:
hey everybody!
I purchased a used 2166 had blown kholer. had 16 hp briggs on an old cadet. are the engine mount holes the same? I used the longer drive shaft from the briggs factory install, but it seems to be a bit short. any suggestions other than slotting the engine mount holes???
thanks in advance, john
Click to expand...

THERE ARE TWO SETS OF MOUNT HOLES. THE PROPER ONES ARE VERY TIGHT, NEED TO TILT THE ENGINE TO GET THE BOLTS IN. AMAZED:cool::cool::thumbsup::confused2:


Footer Links 1

Top