Export thread

Model 7800948

#1

R

ron815

I have a 7800948 snapper push mower and there is way too much slack in my blade control bail. There is so much so that when I pull the bail back to start it, it won't pull enough to let it start. Could I have a link or advice on adjusting it or replacing it. Thanks for your help.


#2

S

slomo

Look where the cable mounts to the bar and at the engine. Make sure the cable run is straight as possible. Might need a new cable, have no clue on your mower. You should see the problem once you look at it.

slomo


#3

R

ron815

Look where the cable mounts to the bar and at the engine. Make sure the cable run is straight as possible. Might need a new cable, have no clue on your mower. You should see the problem once you look at it.

slomo
Thanks. I ordered the parts today, and I should be able to fix it. I just though maybe someone on here had had this problem. Thanks again.


#4

S

slomo

Take a picture of the cable and both ends. Should be something obvious. Could be a bad end connection?? Don't go throwing parts at it without confirming what the real issue is.

slomo


#5

R

ron815

Take a picture of the cable and both ends. Should be something obvious. Could be a bad end connection?? Don't go throwing parts at it without confirming what the real issue is.

slomo
Thanks


#6

R

ron815

It's just a wore out cord. I'm just gonna replace it. Thanks for your advice.


Top