Maintanceman

[handyman357.lw]

Looking for a diagram on location of the charge pump on a Xmark Lazer Z HP. please send me a diagram
:confused2:

 

[BlazNT]

2 things.
1. What are you calling a charge pump. Hydro Pump? I have never heard of a charge pump in my neck of the woods.
2. Need serial number

 

[handyman357.lw]

The charge pump is what my friend called it but it is the hydro pump what i need to know is how do i bleed the air out of the right side the left side works good but the rt. don't engage at all so please can you help thanks

 

[BlazNT]

Still Need the serial number to get the correct manual.

 

[BlazNT]

I dont know if this is your exact model but I found this for beading air after oil change.
Raise the rear of machine up and support with jack stands (or equivalent
support) just high enough to allow drive wheels to turn freely.
g) Start engine and move throttle control ahead to full throttle position.
Move the speed control levers to the full speed and run for several
minutes. Shut down machine and recheck oil level.

On my Husqvarna you raise rear of mower run full forward then full backwards 5 or 6 times to bleed air.

 

[handyman357.lw]

The charge pump is what my friend called it but it is the hydro pump what i need to know is how do i bleed the air out of the right side the left side works good but the rt. don't engage at all so please can you help thanks

I went back over the mower and found one of the low pressure line was sucking air so i need a eXmart part # 1-413273 do you keep it in stock if so please email me price and availability thank you for your time.

 

[BlazNT]

I am not a dealer just a home owner with a passion for lawn care and helping others.