Lawnboy 8251 Restoration
- Thread starter Tristan2021
- Start date
brookwoodbass
Member
I have an 8237! Good luck with the re-build! Post pic when completed! Thanks
Tristan2021
Member
about that i only have 60 psi and i have no spark with a NEW coil. any help?
Check for a faulty on/off switch. Also check the points and condenser (they are under the flywheel). Check the wires for poor connections.
To remove the flywheel, remove the plastic flywheel screen and flywheel nut. Pull up on the flywheel while striking the opposite side with a soft hammer.
Jeff
To remove the flywheel, remove the plastic flywheel screen and flywheel nut. Pull up on the flywheel while striking the opposite side with a soft hammer.
Jeff
Tristan2021
Member
got a new condenser and it sparks good but now where does the rod off of the Throttle shaft go to.
also where does the spring that comes down from under the flywheel go that is in the back of the engine with nowhere "i see" to go?
impalass
Well-Known Member
https://lookup3.toro.com/Ill/1x/5/5682/0003042A.gif
the rod off the throttle shaft rest against the governor lever and the spring attaches to your speed control lever.
Tristan2021
Member
Tristan2021
Member
ALSO IT RUNS!
impalass
Well-Known Member
Don't forget you have to remove the plugs on the drive wheels and put grease in and reinstall the plugs and you should see the grease come out by the bearings.
