Export thread

OK, so I know I should have taken a photo when I removed the head, but I didn't, DOH!
Can't for the life of me rememeber where the spacers go, tried to find a schematic but there doesn't appear to be one antwhere in the ether, can anyone help please?
TC

I’m guessing you have 2 thick spacer/washers you are talking about. If I am correct they will be installed on the two bolts closest to the exhaust valve. This manual might help you out. https://www.mymowerparts.com/pdf/Ko...al-K91-K141-K161-K181-K241-K301-K321-K341.pdf

IIRC, the spacers go under the fuel tank support bracket, if your engine doesn't have one the just use them with the longer bolts.

OK I'll take a look. At the moment I have the cowl on top of the spacers then the tank support on top of them

Couple of pics of what you have will help.

I Have pics but the site says they are too big, I'll post them if someone lets me know how

Spacers go under the shroud so it will tighten flat. Washers will go under each nut.

Thanks guys, looks like I guessed right