My aunt has a hustler fastrak 60. I was doing some maintenance on it last week and noticed both charge pumps were leaking oil. I ordered the O-rings to be replaced. I was able to go over today to work on it. I got both O-rings replaced and have fixed the leaks. I replaced the oil in the hydro system and bled the air. That took a while. Now when I start her up, the engine runs just fine but she won't move. Forward, backward, sideways, up, down, she just sits there. I saw a thread on here from a couple years ago that said to put it on jackstands to take the load off and run it for a while. Will that work? I'm clueless at this point.
thanks
#2
BlazNT
Bleeding the air out of the motors involves putting it on jack stands and running it forwards and backwards with bypass valve open and closed.
ok, I did everything it seems I was supposed to do. Put the mower on jack stands. ran in forward and backward with bypass valves open and closed. Did this for near an hour. It seems I can hear the pumps working, but nothing turns. Am I missing something?
#7
BlazNT
If both are not working check the belt. 2 independent parts do not break at the same time. Check belt routing.
