Export thread

Honda HRX217 Broken roto cable. 200 engine

#1

P

polocash

I have had 2 previous Hondas and never broke a cable.
3rd is a HRX217 200 engine. I replaced $10 wax choke and cleaned the carb white at it. Carb was ok but now like new. Starts 1-2 pulls.

Mowed the entire lawn with no issue and stored it away. Went to clean the leaves and the blade would not engage. The cable pulled out about 5" in plastic housing at the handle end and was snapped in 2. I ordered a new one and waiting. Just over a 3-year-old model, is this the new norm? I even alternate with an EGO and with no rain, little summer use.

Any secrets on installation? Does it need a shot of WD40 once in a while? Someone said the spring is too thick at the connection, at the end of the cable near the blade, and I should change to a thinner spring.


#2

M

mechanic mark

Honda Power Equipment Lawn Mower OEM Parts, CyclePartsNation Honda Parts Nation

Shop our large selection of Honda Power Equipment Lawn Mower OEM Parts, original equipment manufacturer parts and more online or call at 269-385-1540
www.hondapartsnation.com www.hondapartsnation.com
Locate your Honda model & serial #'s above for OEM Parts. No need to replace spring underneath deck nor lube new cable. Cable adjustments should be in your owner/operators manual, BBC & Roto Stop cables should have free play before engaging.


#3

P

polocash

Thanks,
I got the part. Now I have to figure out how to get to the end by blade. I tried to remove the blade and the nuts will not budge. Also, have to remove the shroud? I can not find a YouTube video of my lawnmower being fixed.


#4

M

mechanic mark

Soak overnight with penetrating oil blade hardware.


#5

P

polocash

mechanic mark said:
Soak overnight with penetrating oil blade hardware.
Click to expand...

I installed a new roto cable and can not get it to engage when the handle is pushed all the way. It holds about 1/2 way and then falls off of the hook around the pin. I hope it is a cable adjustment.


#6

M

mechanic mark

Watch youtube above & see if it helps.


#7

P

polocash

It is a different model, but I think I figured it out. I am getting the blades sharpened and then try. I did get the roto button to push in and lock. https://www.hondapartsnation.com/oemparts/a/hpe/5c0f08e087a86612d83732f1/handlebar-2

I was putting 9 in the center of 16 blocking the hook on 14 from grabbing 16. I connected 9 to the outside of 16 freeing the center for 14 hook to grab and hold.


Footer Links 1

Top