Chris Parman
Well-Known Member
- Joined
- Dec 22, 2019
- Threads
- 10
- Messages
- 110
Hello All, here are some pictures of the in-progress GXV120 build.
Items done thus far.
1. Dissembled the engine completely and clean every part, bolt, nut, washer, etc. In a Ultrasonic cleaner.
2. Block bored to .50mm over and honed.
3. New piston (.50mm over), New piston rings (.50mm over), New piston pin clips, all new seals, New gaskets.
4. Checked every part (per Honda Shop manual) for service tolerance limits.
5. As far as new parts are concerned. I replaced (see #3 above).
6. Following all torque settings for all parts during reassembly.
7. Mild porting on the intake/exhaust ports.
It's still in progress
Items done thus far.
1. Dissembled the engine completely and clean every part, bolt, nut, washer, etc. In a Ultrasonic cleaner.
2. Block bored to .50mm over and honed.
3. New piston (.50mm over), New piston rings (.50mm over), New piston pin clips, all new seals, New gaskets.
4. Checked every part (per Honda Shop manual) for service tolerance limits.
5. As far as new parts are concerned. I replaced (see #3 above).
6. Following all torque settings for all parts during reassembly.
7. Mild porting on the intake/exhaust ports.
It's still in progress
Last edited: