JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
Aug 27, 2014 #1
T
tinkertoy
I have put a kit in a 18 hp briggs and stratton carb,its the carb that has the back fire mechanism on the bottom,2 screws holding the bowl on whats causing this to fill the engine block with gas?Thanks in advance.
Aug 28, 2014 #2
P
Pumper54
Sounds like the needle/float is sticking in the open position, you might want to remove the carb/ bowl and see what is going on.
Aug 28, 2014 #3
Briana
Welcome to LawnWorld! :welcome:
Aug 28, 2014 #4
M
Mikel1
Yeah I would check the float needle and float. Did you replace the needle seat?
