Export thread

Craftsman 32cc Handheld Blower

#1

B

Blake99

Craftsman 32cc Handheld Blower, Family YPWES.032.4BL:EM, Model 358.797251, Serial 00286N301440.

It’s been sitting for a while; however, it was run out of fuel and the cylinder was fogged before storage. Have tried to find repair manual without any luck. I am trying to remove the plastic housing to check for critters and to clean the cooling fins. I have removed the screws, except one that is in a deep hole next to the primer bulb area. The screw is covered by a plastic plug. I have not been able to remove the plug. Any suggestions?

It started when I poured pre-mix in the carburetor. The fuel lines have disintegrated, and I am unable to figure out the routing from the tank to primer bulb to carburetor. Thank you for your time.

Blake


#2

Craftsman Garage

Craftsman Garage

Craftsman 32cc Handheld Blower, Family YPWES.032.4BL:EM, Model 358.797251, Serial 00286N301440.

It’s been sitting for a while; however, it was run out of fuel and the cylinder was fogged before storage. Have tried to find repair manual without any luck. I am trying to remove the plastic housing to check for critters and to clean the cooling fins. I have removed the screws, except one that is in a deep hole next to the primer bulb area. The screw is covered by a plastic plug. I have not been able to remove the plug. Any suggestions?

It started when I poured pre-mix in the carburetor. The fuel lines have disintegrated, and I am unable to figure out the routing from the tank to primer bulb to carburetor. Thank you for your time.

Blake
lotta problems on this blower lol


#3

Craftsman Garage

Craftsman Garage

try shooting som starting fluid in the carb or sparkplug hole


#4

Craftsman Garage

Craftsman Garage

if it runs or even fires a bit then your engine is good and you prob need a new carb and fuel lines (y)


#5

B

Blake99

It will run with pre-mix poured in carburetor, need to know how to remove plastic housing and fuel line routing.


Top