Hi folks. I removed the carb from a B&R model 124707-0215-01 engine that's on an old DR. Power Wagon. The choke return spring fell off and I cannot figure out how to install it. Can anyone come up with a diagram for it. I downloaded the parts manual but although it shows a picture of the spring, it doesn't show how it hooks up.
Thanks, Wally
#2
Scrubcadet10
I typed in your model number on multiple sites and none of them had the engine with a choke, only Primer....
If this is in deed a auto choke engine, this should help.
I typed in your model number on multiple sites and none of them had the engine with a choke, only Primer....
If this is in deed a auto choke engine, this should help.
ok my bad, i did not see there were 2 sections in the IPL, one for the choked carb, and one for the primer carb.
Personally i've never worked on one with a manual choke so i can't tell you. but I'll bet you some of the other guys on here can.
ok my bad, i did not see there were 2 sections in the IPL, one for the choked carb, and one for the primer carb.
Personally i've never worked on one with a manual choke so i can't tell you. but I'll bet you some of the other guys on here can.
Thanks Rivets. It shows where the spring hooks up to the choke lever but not the other end which is the end I need to see. At least it shows the general area and direction that it goes and that's a great help. If anyone has a pick of the other end I would greatly appreciate seeing one.
Thanks, Wally
