briggs and stratton 19.5 hp engine wont turn over.

R

rolltide84

Forum Newbie
tried jumping my craftsman mower with a 19.5 hp engine and fried the solenoid. replaced the solenoid and now when i try to start it, it will turn maybe half a turn, making a god awful noise and then stop. then if i turn the flywheel back to where it is free, turn the key and get the same result. any suggestions????:confused2:
 
Your valve clearance is likely out of adjustment. There are several threads to adjust them on this site. It is an easy fix but I found mine needed tighter intake clearances than where called for.
 
thank you sir! i will try that! what causes that, by the way. I had been cranking it over quite a bit cuz it wasnt starting. after some maintenance, i ran into this problem and dont even know if its going to run....
 
Rivets, if that was the problem, what would the solution be? Buy an entire new starter or can you replace the bendix itself?
 
Thanks for all the suggestions too, fellas. I havent tried any of them out yet. i married into a big family and have to spend this weekend travelling. but i really appreciate the suggested remedies. i will let ya know how they go.
 
You must log in or register to reply here.
Back
Top