JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
Aug 23, 2022 #1
M
Mchernecki
I have a 675exi model 103M02-0008-F1. I was cutting the grass when it just stopped. I tried to start it and it fired up for half a seond and stopped. The next day it would not fire at all, tested it and no spark. I bought a new coil and again it fired for half a second and again no spark. Any ideas?
Aug 23, 2022 #2
Scrubcadet10
test for spark with the small kill wire unplugged from the coil.
Aug 23, 2022 #3
M
Mchernecki
test for spark with the small kill wire unplugged from the coil.
Can't check till tomorrow. I will let you know. Thanks
Aug 24, 2022 #4
M
Mchernecki
test for spark with the small kill wire unplugged from the coil.
Ok, disconnect the wire and it runs fine. Just can't shut it off without pulling the spark plug boot.
Aug 24, 2022 #5
S
slomo
Ok, disconnect the wire and it runs fine. Just can't shut it off without pulling the spark plug boot.
You are onto something. Something is grounding out the coil. Need to see what it is.
Aug 24, 2022 #6
M
Mchernecki
You are onto something. Something is grounding out the coil. Need to see what it is.
Is there any switches that may be bad or just wires that may be grounding out?
Aug 25, 2022 #7
S
slomo
Is there any switches that may be bad or just wires that may be grounding out?
Trace that kill wire out and see.
