JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
Apr 15, 2023 #1
D
davesdrumzzz
My !996 John Deere 48" Commercial Walk Behind Mower blades will not engage. Kawasaki engine starts and runs good but blades will not engage. Any advice on what to look for would be appreciated.
Apr 16, 2023 #2
M
mechanic mark
Test PTO Switch at dash with multimeter above.
Adjust air gap at PTO Clutch or replace, be sure to Burnish new clutch per instructions.
Apr 16, 2023 #3
D
davesdrumzzz
I will let you know what I find. Thank you for your help.
Apr 29, 2023 #4
D
davesdrumzzz
Thank you Mechanic Mark, your advice was right on. It was the PTO safety switch. Replaced it and the blades engage. Thanks again .