troy bilt

I have a Troy Bilt Bronco 13yx78ks011 and the brake rod doesnt have enough throw to engage the brakes. It's almost like the brake rod that connects to the spring on the caliper is too long. I did notice that its hanging down below the frame. Theres nowhere to adjust it and nothing is bent. Its...

2003 TROY BILT RIDING MOWER MODEL NUMBER-13WV77KF066-- PONY LEFT SIDE DECK SPRING, WHERE DOES THIS SPRING CONNECT? THANK YOU

help, i have a troy bilt 13an77bs011 riding mower i need to take off flywheel cover under the shroud. so does the nut ,that sits on flywheel inside cover turn clockwise or counter clock wise to remove. i think the pin is sheared thanks

Hi, I’ve got the mustang xp 50” zero turn. The right trans has been weak for some time but not too bad. Recently the drive belt broke, so I replaced it. Afterwards, we mowed right away and it seemed ok. Next mow, it was weak on both sides and after an about 30-40 minutes, it was bad. Moving in...

Hi farrell here i dismounted the crbulator spray som clener and put it back but dont remember how the linkage goes on thanks in advance

2003 model # 13WV77KF066 There is a spring on the left side deck and the forward part of the spring is broken. It is connected at the back but I cannot figure where the other end is to be connected. I hope someone can tell this girl where it connects and maybe post a pic. Thank you

Hello All, I'm SEARCHING for a Brake Rod Support p/n 1762599. All dealers and supply houses tell me it's NO LONGER Available, ugh... IF anyone has a lead on one NEW or good used, PLEASE contact me. Thanks ! Mr Ken

The spring for the accelerator pedal (on right side) must have broke as the pedal collapsed forward and the mower doesn't move forward anymore. I bought #38 spring (732-04612) to try to fix it but I'm unsure where it attaches or if there may be some other parts missing. I looked at the...

All of a sudden I'm not getting power distributed after ignition switch. New Battery and switch installed. So it's neither a battery or switch issue. Power to the switch confirmed with a meter. When key switch is off it shows full 12 plus volts but when key is turned to the on position no power...

Hello, can someone tell me what size ccu I need for my Troy bilt Horse with a 20 HP Kohler 597 cc? I have spent almost an hour looking online and cannot find an answer. I know I need a U1, but unsure if it needs to be 230 or 300. Thank you!

My troy bilt horse xp hydrostatic 46" cut riding mower will start and the engine runs fine. The blades will engage and operate correctly when engage the PTO. But it will not move forward or backwards when try to put it in gear. What do I need to do to get it to work and drive?

Over the weekend I bought a Troy Bilt riding mower (22 hp engine 46 in deck) from a friend and the only issue it seems to have is that the deck wont engage in high gear. For reference, it has what I call a Hydro-Shift transmission (shift into forward high, forward low or reverse with a shifter...

I am wondering if it is possible to adapt an 8HP engine to the 4HP unit I currently have. The carb is probably junk and the unit really needs more power but I do not want to pay the rather high price. Thanks!

2020 Troy Bilt Pony 42 7-speed riding mower will run in reverse but stopped moving when in forward. It became slower on one cutting day,then more slower the next, now will not move in forward.