transmission

****Updated with Mower info*** I have a 2016 Hustler Raptor SD 54 Kohler 7000, Spec PS-KT740-3042 725cc, Serial 4601931503 mower, manufacture 03/2016 SN 934604, Hydro-Gear Model ZH-MCBB-3EMC-3PXX SN 6059D90011. When I shut the engine off, I hear a loud rattle around the engine or transmission...

Do the Forum members think there is any benefit in changing the hydrodrive/transmission oil on a Toro Wheel Horse 17 hp? (FYI mower performs very well but in the past I have had a hydraulic transmission fail & have always wondered if a timely oil change might have extended its working life)...

I just repaired a John Deere 108 lawn tractor and is running good but I am not sure (and can't find anything on this) if the rear end transaxle gear housing oil should be changed. First off, I can't see a drain or some place to fill it so that would probably be my first question - where is it...

Hustler Raptor SD60. Drive belt failed and I put it in drive with levers and towed it about 75 feet behind car and wheels were turning(I was tired and forgot to release transmissions). I eventually changed drive belt and tested drive function in air on jack stands(it passed). I set it down and...

I picked up a used Toro 22” Recycler model 20332 serial 313040024. The transmission was not working correctly. As you look at the photos you can see someone was in the transmission before. I would like to find a parts diagram for the inside of the unit as I think the issue is they reassembled...

ZTX5 with ZT3200 Hydro Gear pumps. Anyone used their kit to change fluid ? Thinking about doing it myself. Just wondering how difficult it would be.

Hi, I need the diagram on how to rout new belt. Thanks Earl

Just replaced pinion gears, and adjusted the drive engagement: Under no load the rear wheels full engage and drive properly, but in use if I "fully" engage the paddles, the gears "chatter" and seem to skip. (Note: the old pinion gears were substantially worn done nearly 75% of the way, with only...

Does anyone know where I can get a good used #532161592 pulley. It is no longer manufactured and I have looked everywhere on the web. Also, is there an off the shelf replacement that could work as a substitute? It would seem that out of all of the pulleys in the world that there would be...

I ran into a stump under some leaves and the most won't move. We have 4 parts machines that all had good transmissions when parked. We swapped out all four transmissions and each one it moves 6 " to a foot and quits moving. My guy tore apart the original one and everything is fine. We are at a...

My craftsman T3000 is losing its reverse drive, it has the general transmissions rs800 cvt transaxle. I replaced the belt and cvt pulley only a few months ago. The belt has a small bit of wear but doesn’t appear stretched. Is there any adjustment somewhere in the linkage that I can adjust to get...

Hello all, I can find this pulley on the Honda parts websites, but there is no part number. Item 15 I believe. Transmission number is 20001-vl0-m00 Does anybody know the part number for this? Possibly have a link? My son's lawn mower and I would hate to have to buy $155 transmission just for...

Looking for a repair manual or video on removing the transmission. Any help would be appreciated. M

Whoever has a Deere database, can u tell me how much trans fluid the G100 tractor K66C(at least that's what I found online) transmission holds? I find conflicting numbers online - 1 quart 2 quart, 1 drain bolt, 2. I drained mine and it takes 1 quart and upon shaking the tractor, I see the fluid...

The last couple of times I have been mowing with this mower it has been pulling to one side or the other. It might go straight for 10 feet then all of sudden it will pull you one way to one side. Then it will come out of it and you go another 10 feet and then pull again. It isn't consistent...

Hello to everyone, looking for some advise. I have a bit of a problem with my 2004 stiga park pro 20, The power assisted steering is gone knotchy and hardish to turn either way, I have changed the filter and the oil. I think the transmission and the steering share the same system and oil. Has...

Is there a maintenance schedule for the transmission? I've had the same mower for over 20 years and if there's fluid in the transmission, I'm thinking it could be due for a fresh refill. Also, exactly how would I drain and refill the fluid(s). Also, has anyone discovered a way to replace the...

I located an oil leak in my transmission coming from behind the control lever. Looking at the parts diagram there are a couple o-rings behind the control lever and 2 pins that hold the control lever on transmission housing. Any help on how to remove those pins to free the control lever so i...

Anybody have any experiences, either positive or negative, with the Tuff Torq TZT7 transaxles?

I have a new Broadmoor with less than 30 hours. When mowing under my gum trees it often throws the drive belt at the trans unit pulley. I think the deck is picking up Gum balls and they are being thrown under the drive belt causing it to roll off the pulley . Has anyone experienced this and...

I took the blade off, prompt up the mower, started and engaged the transmission and it doesn’t appear the pulley on top of the transmission is spinning. Should that pulley be free moving? Would I gain anything by taking off the small plate on the side to see if something is locked up? Seems I...

I have a Toro MyRide 54 zero turm mower and the left transmission gets noisy and weak after mowing for 30 minutes or so. I can't find a dipstick, fill plug, or filter on this model. Does anyone know how to check the fluid or have had a similar issue?

My transmission belt keeps breaking. Is there a tension adjustment, if not any suggestions?

I've got an older apx. 2000' 20hp I believe, LT2000 Craftsman rider. I'm told the transmission is shot. Can the transmission be replaced with another craftsman transmission, say from a LT1000, Are parts like that interchangeable? Thanks guys

JD E120 does not go forward or backwards. Do not hear any whirling or grinding sounds just does not move. Tractor can be rolled forward and backward whether the bypass rod is engaged or not. When it’s engaged, there is a little ticking sound as it rolls backwards. From previous car experience...

Good morning, is there anyway to order this part alone instead of buying the whole assembly?

After pulling my mower out yesterday I noticed while mowing it was starting to slow down. Let off on the pedal then pushed back down and it seemed to work fine. It keeps doing this so I stopped and called the dealer who said to check the drive belt and the splined pulley. It is up under the seat...