simplicity

What the heck is going on? Sure hope someone can set me straight on this. My Broadmore 48" fabbed deck height adjustment motor won't work from the dash switch. I've checked for power at the connector at the motor and get +12v and -12v from the switch. I then put 12v directly into the motor...

Hello LMF, I have a Simplicity with a steering rod? issue and was wondering if anyone had suggestions. Details: Simplicity Regent B&G 22 HP 44" Cut Part No. 2690575 Serial No. 2012695011 Issue is the steering rod (guessing that is what it is called) has fallen out at the ball joint that...

I got mower out today, for spring cleanup. I had very slow forward, no power in drive and almost no reverse. does it have fluid in rear for drive ? Any advise, Thank you.

Troops, I have a 2013 Simplicity Prestige (27 hp Kohler) which I am going to sell because I bought a new mower. When I moved it in the garage, I found a small oil spot that turned out to be from the hydraulic cylinder. So I got online and looked the part up and had to be defibrillated when I...

I thought it would be good idea to replace rear axle oil and filter. I'm quite sure it never has been. However, now I cannot locate a correct filter. Anyone here, have any experience with this issue. using Mfg part number comes up no longer available. Is an automobile automatic...

Hello, looking for advice. My Simplicity Regent with the 24HP Briggs twin will crank but not start. The tank is full of fuel and if I disconnect the fuel line after the fuel pump when I crank it fuel is squirting out. When I shoot starting fluid into the air cleaner it will pop and run for a...

I have a 40" 2005 Simplicity Broadmoor. The deck has rusted and I have not been able to source a replacement. I was wondering. Given that the deck simply : 1) hitches to a metal bracket on the underside of the tractor 2 and the PTO bely wraps around the POT wheel 3) and the long arm of the...

About two years ago, my Simplicity mower blades started noticeably slowing down when I reverse it, which I do frequently. It works fine when going forward, but when I step on the reverse pedal, I can hear the blades slowing down considerably. It still mows, but not as well. I changed the...

I have a brand new, old stock Simplicity Courier Zero Turn that won't start. Mowed yesterday for about 4 hours, refilled the tank and parked it last night. Went to start it today and it will not. It cranks and spits and pops but will not run. The safety interlock on the seat, steering...

Hello All - Here in WI I am having difficulty snowblowing on a slight incline with my Simplicity Broadmoor 1693601. No chains currently, but I do have rear wheel weights. Has anyone had experience with the Legacy or Prestige 4x4 units? Are they reliable? Hesitate to run chains as I don't...

Just purchased a brand new (old stock) Simplicity Courrier ZTR (2691661) and am in the process of adding it to my small engine specs spreadsheet. I've culled through all the books the dealer gave me with it but have no idea what type of oil to use in the drive units. I'm assuming it's a...

I was changing the oil and filter on my 38" simplicity with an 18hp Intek single cylinder. It had a brass fitting that attached to an aluminum block that screwed into the cast iron casing. Needless to say what kind of engineering process designed this. There was also a...

I located an oil leak in my transmission coming from behind the control lever. Looking at the parts diagram there are a couple o-rings behind the control lever and 2 pins that hold the control lever on transmission housing. Any help on how to remove those pins to free the control lever so i...

Simplicity Regent 12 witha 12.5hp Briggs 289707 1 cylinder 4 stroke running incredibly rough, smoking, stuttering. On lower power settings it will smooth out for about 3-5 seconds then die, on high power settings it stutters and runs extremely rough, never smooths out. Has an integrated...

The clutch / brake when released cuts out the engine. I have the seat switched jumped and the two switches activated by the clutch/brake arm work fine and tested good. Tearing my hair out. Anybody know why or have a wiring diagram? Cant find one anywhere!

I'd like to sell my mower. How do I go about finding the year of the machine? I have the model and serial numbers.

Hello everyone! First off, please excuse my language illiteracy as I really don’t know much about these machines. I was just given this machine by my wife’s aunt as it’s been in the family for 50 years. She said she had it serviced before giving it to me, but after mowing for 20 minutes it...

I'm looking for bearing type/size used to this part 1676278SM Arbor Shaft & Bearing Briggs and Stratton OEM. I need to replace it

Hello All - Working with a new-to-me Prestige 2691130-00 and wondering what your procedure is to adjust the snowblower (42" single stage) level with the ground? With my old Broadmoor that had the manual, lift I just put a piece of paneling under the blade and adjusted the shoes accordingly...