Thanks for reading. I have a JD LA105 with a 19.5 single cylinder OHV. Replaced the head gasket, common cause, the mower starts and runs great but after a minute or two it starts bleeding oil out the fuel pump and breather tube. Wispy smoke when I pull the dip stick too. I adjusted the valves...
I overhauled my hydro pumps after a slow leak for a couple seasons now. After replacing the seals and reinstallation, I followed the procedure to purge the system while the transaxle is released, then reengaged, but still have frothy oil. I can’t find any leaks from the pumps anywhere and the...
I'm replacing both hydr. pumps in an '08, IS3100Z (with the 26 or 27hp liquid-cooled kawasaki).
Btw, I don't see a drain plug on the hydraulic drive units/ motor at each wheel. My goal is to get rid of the old, black oil in the drive units. How?
Right now, both pumps are out, and there...
I have a ZTR mower that had a failed Kohler engine. Replaced it with Vanguard EFI 28 hp. Changed the pin orientation of the Molex connector on the ZTR to match the Vanguard motor. I have no safety switch issues that would stop fuel pump from being energized. The engine cranks, I have spark, but...
Hi,
Was gifted this older Pressure Washer and looking to rebuild the Pump.
No name on Pump, it is a 4 Screw model and looks like a Kurcher Brand but no label or markings.
The Pump for this model # at EReplacement parts is not the same pump???
They want $350 for a new pump.
Will try to...
John Deere rider with 19.5 HP B&S model 31P677 just stopped running today. Same thing happened a few weeks ago, fuel filter was stopped up, replaced filter, everything seemed fine until today. Mower stopped and there is very little gas in the filter - maybe 5-10 drops. Time to replace fuel...
I have a Kohler engine KT725-3031 that I can't get to run. I've replaced the fuel pump and carburetor and it will only run with carburetor cleaner for just a second. Fuel is getting to the carburetor, at least to fuel filter.
It has a thermostat assembly 32 755 27-s that attaches to the side...
Hello there
I replaced the fuel pump on a 2006 zd28 about 4 years ago with one I bought off Amazon. It went out the other day and I again replaced with an inexpensive one I bought off amazon. Two mows in and now it failed. My question is did I just buy a lemon or could something be burning them...
I have given up on aftermarket electric fuel pumps for my 727A zero turn mower. I ordered the JD
AM876265 on faith but would like to know the output pressure range which I cannot find in any of the ads/pubs. Anyone out there know the specs?
Grasshopper 616 Model with a Briggs model 356442, Type 0224-81, Code 090119. Is there any way to check the oil pump before I order a new one? Is there any specs. on the pump that I can get?
Badboy Kawasaki FD731V72106 FD731V AS09 How can I test the fuel pump. The emgine area is making a slight grinding or spinning sound with the key on that I don't think it used to make. The engine is not runnning at the time.
Engine only running for a few minutes and when it gets hot or warmed...