pto

Hello All Model: XT1 M/N: 13WQA1CQ009 DOM: 03/2015 S/N: 1C125H20445 Engine: Kohler 7000 Series 24hp Cub XT1 50" Shuts Down when PTO is Engaged. It doesn't sputter or anything; the engine just shuts off quick With Deck removed (no load), the PTO engages just fine. This tractor has just 50...

Hi All, Last year the PTO clutch locked up and because of this, I couldn't start the engine as the engine wouldn't turn over. The repair shop nearby told me to order a new PTO clutch and I did and they replaced it. I only used the PTO for 19.1 hours this year and the mower stopped again while...

Update! -No compression in either cylinder. Guessing head gasket? Worth repair or get new motor? Hi. I have a Husqvarna mzt61. Fired it up, engaged pto. Blades spun. Through earmuffs sounded rough\racket and maybe weak. I shut it down. After looking things over, it will not start. Cranks...

I have a Craftsman Pro Series 8200 that the electronic PTO was cutting off when mowing the yard. I did a lot of research and replaced the PTO switch, Electronic PTO clutch, initially and still had the same issue. The mower at times seemed to not want to start ( already have new battery) and so...

A couple of years ago advice from this forum helped me set the air gap on my Ogura clutch on my Freedom Z. Everything seemed fine until recently when I started hearing a loud "scraping" sound seemingly coming from the clutch when the blades are disengaged. No unusual sound when engaged. I...

Bad boy outlaw extreme with the 850 Kawasaki engine shuts off after 60 seconds of engaging the PTO. Replaced battery, replaced fuel filter, cleaned air filter. Replaced a bad PTO switch. Jumped out all the switches, does not matter if jumped out. Ran the mower in idle for several hours and its...

Ok this just started happening, 2019 AT eilite runs fine then a few weeks ago it runs then engage PTO it runs good then it bogs down i say about 1000rpm stays like that for about 8 seconds then goes back to full power for about 15 seconds then bogs back down again does this over andover...

Looking forward advice on removing the PTO lever.

looking for a PTO Clutch 5104572FS - hopefully from a source that actually has one available... Ferris said they did, but that was 3 weeks ago now!

So I own a Huskee LT4200 with a Kohler courage SV530-0222. I went out after winter to start it up and the solenoid just spun and did not rise to engage. So I replaced the solenoid, same symptom. Then I heard chattering coming from under the seat, so I think relay, replace that. Same issue, then...

switch off and they disengage when I turn the switch on. Happened all of a sudden while using the mower; I may have cut it off to answer a call but I was still in the mower. I suspect seat switch, PTO switch or clutch? Looking help.

I have a 2005 Exmark Lazer (about 700 hrs) and am having a vibration problem with PTO clutch. While disengaged, there is vibration and wobbling of the clutch on the engine shaft. Thinking it was a failed clutch, installed a new one with same result. Worrying about failed lower engine shaft...

I have a 2004 Husqvarna lawn tractor GTH 2548B, serial # 081604B003442 with a Kohler Command 25 CV 730 with an electric pto problem . It runs good and has low hours of usage and well cared for. When I pull on the pto starter switch for mower deck it starts to run for a few seconds then stops the...

Hi All, Mower Info: Snapper Pro S200XT Professional, Model # 5901280. Engine Model Number: Briggs & Stratton 49T877-0010-G1 Quick Summary: Last year I changed the PTO switch because it had gotten loose. Later in 2023, the PTO clutch locked up and I had to have the repair shop replace it...

Over beers a guy told this tale about his mower dropping to 9v. Alt puts outs 13+v. I just read a thread about pto killing engine but here engine runs fine, pto engages smoothly at wot but the dash volt meter drops to 9v and tractor continues to run until the battery is dead. This just has to be...

I have an Ariens SportZoom 1232 I've had since 2004. Just recently I noticed the blade does not stop if I turn off the PTO. I checked the PTO switch and it appears to be working properly. So I think this means the PTO clutch is stuck in the engaged state. That seems odd to me as I would expect...

I have a Troy-Bilt 42" riding lawnmower, Model #: 13AK78BS011. It was working but the drive belt kept coming off when I would turn off the mower. When the PTO lever was not engaged, the belt looked extremely loose. I also have the belt retainers on close to the pulley. So I took the deck off and...

This will likely sound so rudimentary as to expose me as a dunce. 2008 Cub Cadet i1042 Zero-turn riding mower. How bad is it to engage the PTO with the mower deck removed? Every time I engaged the PTO the mower conked out. The belt did not seem to have slipped from the pulleys and it had worked...

PTO Cable snapped on my mower. Replaced the cable and have everything back together except the golden spring that connects to the PTO Handle. I know where the spring connects to the handle/lever, but it's been a few days and I've forgotten where the other end of the spring connects to the...

About five minutes into mowing with my replacement mower the other day and it appears the PTO or PTO switch went bad as the blades disengaged and wont re-engage when I pull the switch. I have never worked with an electric PTO before. Does anyone know if the switch can be removed from the dash...

RZ5424 about 15 ys old. Runs fine. Had a fuse blowing issue first. Which led to lots of new switches and parts thrown at it. Two things. Release brake engine stalls, engage pto engine stalls. Has to be a safety switch issue. Tested them all good. By passed seat switch. Engine runs well...

So, my new Cub RZT-L works fine for maybe 15 minutes, and then the PTO kicks off. I can push the switch down and back on and mow again, until about 30 minutes in. After that, it has to be parked, as if something is getting hot and needs to cool down. I changed the PTO switch and hunted for a...

Hope someone can help. Replacing PTO clutch while transmission is in the mower My PTO was barely turning I took it apart thinking the clutch was gone sand actually one of the brake plates had a bent tab and that must have been holding up rotation. In any case I replaced the clutch friction...

i may have tried to engage the PTO while over a tree root. bad noise; threw the belt. replaced the belt. now PTO will not engage. Any ideas on next step to diagnose problem? The rest of the mower runs great! Thank you.

After getting this unit running, I go to test the mower part of the tractor and when I engage the PTO switch (pull out and flip up), the mower goes to shut down. It's as if the key is being turned off. I do have the wiring diagram. And side note, see that the seat connector has a piece of wire...

What are the two permanent magnets under the two brake pads for? My clutch jammed somehow? and when I engaged the PTO to cut, it ripped my belt apart. On disassembly I found one of the magnets shattered. I reassembled the brakes minus the broken magnet and I don’t see any difference in function...

So back in May my boss bought a basket case IS1500Z. The story we got was that the motor "Kawasaki V-Twin" blew up last summer and the previous owner rebuilt it. When my boss bought it the drive belt was off along with the PTO and deck. I was able to put everything back together and he has been...

Does anyone know how the band cord #175 below is used to secure the PTO Stopper #170? I can't figure out what it is intended to hook around besides the stopper. It may be intended as an anti-rattle device as the PTO has several mm of twist. This rattles when blades are engaged. I have replaced...

Hello, anyone know where the PTO safety switch is located on a Cub Cadet LT 50 XT1 Model 13A0A1CZ056 Serial 1E149H20171 ?

Good morning, I'm in France and have a Massey 2924d (same as Simplicity Legacy I think), with the 24.5hp Daihatsu diesel engine. I have a couple of questions: Won't start on the key. I have power at the starter solenoid, but only about 8v. The only way I can get it to start is direct feed from...

pto dies when i push switch to mow in rev erse

Hello I have the pilot bearing near the sheave gear go out. I have replace both pilot bearings and started mowing and the pto clutch started howling. Unit has 800 hrs . Which I think is bad. I have a new oem clutch, but asking the experts if I should buy the stub shaft and replace both at...

Belt getting hot, checked all deck pullies spin freely, replaced tensioner spring, PTO engages wben pressed. Belt and pullies running but belt getting hot. Shut down and checked pto clutch is hot to touch. What is causing this?

my pto is cutting out intermittently. Getting 14v at battery when running. Even when just starting to mow the pto will shut off. If I shut off the switch and pull it back up pto will start to go then cut out again. Electrical problems are not my strong suit so any help is appreciated. Any...