pressure

I've been reading lately in miscellaneous forums that folks are inflating their drive and front tires with pressures of 8-12 PSI. I have a Hustler X-ONE, and for all of these years I have been inflating my tires with the max pressure embossed on the side of the tire (20 PSI rear, 28 front). It...

Hey guys tore down my 19 hp kawasaki in my Toro commercial zero turn mower...new rings .gaskets etc....only problem the center case gasket I ordered they sent the wrong gasket after two weeks so just used rtv sealer like newer mowers use. Only problem is the two oil pump o rings were damaged and...

Hello All. My neighbor picked up a mower for $20, asked me to get it going. It’s a Troy Bilt with a Briggs and Stratton 550EX, 140cc motor. Motor model 09P7020144F1. Engine made in 2019. Initial issue was it would start but quit quickly. Found fuel was saturated with water. Drained...

This one has me stumped. Carefully pressure washed this backpack blower and it won’t start. I am getting good spark to plug. Sprayed starter spray to carb inlet no luck. Disconnected kill switch. One thing I noticed, if I pump primer bulb then disconnect fuel inlet to carb, it was...

I have an older John Deere 185 hydro. I can't find the release so I can push it. The Serial # is M00185B454279 185 Lawn Tractor W/46" RM One of the techs at my local dealer says he thinks there is a lever on the right side under the fender but he isn't sure. Any ideas???? Thanks in advance.

Lets say you are working with a tractor or other vehicle that weighs around ten thousand pounds. You have one of the wheels off and you fill it to about 60 psi which would be about right for a Class E tire. You put the tire back on and lower the vehicle to the ground. You check the tire pressure...

Briggs & Stratton 8.50 H.P. Pressure Washer cranks & runs good for 30 minutes then dies, replaced the carb & the coil still have the same problem ?????????????

I have recently obtained a Hustler 295 Mower with a ONAN T260G engine. The Hustler has an oil pressure gauge which was a mechanical gauge, however, the oil tube was cut. I haven't been able to locate where the tube would have gone. Was there an oil pressure sending unit in the ONAN T260G? I'm...