no spark

I have an 80's AV520 670-05F 3hp 2cycle vertical shaft engine that does not have spark. I have replaced the coil, condenser, and points. The kill switch is good and actually not connected at the moment. The points and plug are gapped correctly, the flywheel magnets are good, the air gap is fixed...

I bought a used Mastercraft Yard Beetle,guy said it needs solenoid and shift cable but runs by direct jumping the starter. Got it home and does not fire up,direct jump to starter and turns over.I got a new solenoid and nothing on the key??? I direct jump the starter and it turns over but not...

Kohler cv15s on a John Deere lx255 has no spark but cranks over put new module in and same thing

Mower usually starts one or two pulls. Compression feels good, getting fuel because spark plug wet when I pull it. Plug measures 19k ohm tip to electrode, about 3m ohm tip to threads. Should be infinite correct? Also coil reads 5k ohms plug wire to coil frame, 5k ohms plug wire to kill tab, and...

Have an issue with no spark on my 22 hp 7000 KT725-3012. When cranking the spark plugs are not firing. When key released will see a quick flash on the plug tester indicating power to plugs. Whatever is inhibiting the spark during the crank process is released for a second when key is released...

I changed spark plugs, cleaned the magnets on the flywheel and coil, removed the ground wire from the coil, but could not get a spark. The gap between the coil and the flywheel is .010. The ohms between the coil legs and the spark plug wire lead, and the coil ground wire lead and spark plug...

Hello All Stihl 090 Actual age unknown Guessing 1978 First, I feel not so smart right now. Today is the day I can't diagnose the cause behind no spark on an electronic ignition setup Coil tests good at 7 Ohms Kill switch is disconnected New ignition module New Ignition mounting plate. The...

I am working on a BS 44 m777 0148b1 that has no spark from either module. I have disconnected the ground wire and still no spark. It just doesn't seem right that both modules should go at the same time?

Got two hr215 that am trying to fix up and one of them has good spark at plug. took that coil and plug off and put on other mower, unhooked the kill switch,and gapped the coil the same and am not getting spark. besides flywheel what could be causing that? anyone know if flywheels go bad...