kubota

The wife is interested in getting a ZTR for our place in the country. We have two places 1/4 mile apart. one is 12 acres with slight hills lots of grass and the other is 25 acres bigger hills and mostly wooded. I already have a 60HP tractor that can handle the bigger jobs. The three brands...

Can anyone advise on the correct way to remove the front wheel bracket on a ZG127S?

2020 Kubota with Kaw FR651v, 80 hrs. I have a constant 12v draw at regulator, even with key turned off. I am pretty sure it should be zero with key off. Can you point me to the test procedure for the ignition switch? What else might send voltage to the regulator? It runs fine and is charging the...

Hi folks I crossed bit metal on my dad's ride on kubota, didn't know what was happening at first till I stopped blades and moved forward, there now a rattling noise from that side when blade running, iv looked underneath all looks fine and blade not rubbing when moved by hand but I know little...

Has a Kawasaki fr 651v engine. new fuel, spark plugs, new fuel line and carburetor and fuel with filter engine surging and when I engaged the blades it dies. any idea what it could be?

Hope someone can help. Replacing PTO clutch while transmission is in the mower My PTO was barely turning I took it apart thinking the clutch was gone sand actually one of the brake plates had a bent tab and that must have been holding up rotation. In any case I replaced the clutch friction...

Kubota 54" Model Z724 Best way to clean blade area?

Does anyone know how the band cord #175 below is used to secure the PTO Stopper #170? I can't figure out what it is intended to hook around besides the stopper. It may be intended as an anti-rattle device as the PTO has several mm of twist. This rattles when blades are engaged. I have replaced...

My old Kubota with the 15 hp Kohler became almost impossible to start. For a year we struggled with getting it to fire strong enough to overcome the compression release. Once running it was powerful and ran normally. Then, getting it ready for this summer's mowing I could not get it to start...