john deere

I have a John Deere E120 lawn mower which I've owned for about 4 years with a snowblower attachment. I live in Minnesota and the snowblower isn't able to move much more than about 3" of snow, we are expecting 6" tomorrow. I thought there might be an issue with the belt so I went to the...

My John Deere A105 riding lawn mower hums and then it will finally start just one time. Turn it off and it hums and will not start. I have changed the spark plug, gas filter, air filter, ignition switch, and solenoid switch, What is the problem?

had this jd ztrak 25 hp 60 inch deck running,and stopping several times to test safety switches , stopped engine went to restart does nothing, the pto will engage could i have a start relay have gone bad. any cooments will be helpful thank you

I hope someone can bail me out here....For some unknown reason, the starter on this mower burned itself up while mowing? Really?? Can that actually happen? Anyways, it's toast. The John Deere part number is MIA12264. John Deere has informed me that they do not have them in stock, and if they...

I have an issue and need some help. I serviced a very abused Z335E. It ran fine after I was finished and I parked it in anticipation of washing it to returning it to the customer. Now, nothing. The battery is fully charged. I found a blown fuse and changed it. I also found the switch had been...

I just repaired a John Deere 108 lawn tractor and is running good but I am not sure (and can't find anything on this) if the rear end transaxle gear housing oil should be changed. First off, I can't see a drain or some place to fill it so that would probably be my first question - where is it...

Just recently the lawn tractor has started backing up very slowly. Forward is fine. Any help would be much appreciated.

Looking at buying a new Garden Tractor and seriously considering the Husqvarna TS 348XD. Want one with a fabricated 48" deck and locking differential. Do not want a spindle style rear end. The John Deere is a little bit more than I want to pay with the Deck and locking differential. One of the...

Hey all, Got a 1999 GX85 gifted to me to fix up for my son to learn how to maintain amd drive. It's been sitting for years and just starting to pull the basics now to get engine running. The 13HP factory Briggs on this thing (Briggs & Stratton 28M707 per Tractor Data) doesn't seem to have an...

Does anyone have an idea what caused this problem? While mowing my blades stopped spinning. It was if I pushed the pto to stop the blades. When i pull the pto to engage the blased I hear a click, but nothing happens. The belts are on, all the fuses check ok.

I have a 190 John Deere,no spark on the solenoid,no click when I turn the key to start,new battery. I was mowing and just stopped Please Help Me

My 727A starts on the first crank when cool. After an hour or so, when hot, it will not restart after shut down. I have put on new carbs, gone through the complete fuel system (including putting on electric fuel pump which runs fine when hot), replacing plugs and both ignition coils. Nothing...

Hi all, I have a C108 lawn tractor that won't start. Battery is good, turning the key, there is no click from the relay/solenoid. The ignition switch feels mushy but without a diagram, I can't tell if it's a problem or not. I am looking for an electrical diagram so that I can chase the issue...

I just took the shaft out to lubicate the slip end. Dropped the parts and can't figure how to get it back together, Thanks

John Deere LX 279 blew blue smoke. Forums said it was blown head gasket. Tore it down and both head gaskets were fine. Re-assembled but still running very rough and jerky. No blue smoke this time. Any advice to try next?

Anyone have an idea about how to remove the Hour and Fuel guage display from the dash ? I have unplugged the wiring harness but have no idea on how to release the display from the dash. I have pictures but couldn't upload them here for some reason. Thanks

Have replaced the starter solenoid, starter and ignition switch. When ignition switch is put into the start position I get a loud click that sounds like it is coming from the engine area but the starter will not engage. My fuse block also has an issue. There are 3 fuses in the block, the center...

I was cutting grass last week, and accidentally hit a heavy rubber watering pan. It got lodged in the deck. The tractor would run fine until the blades were engaged, then kill out. A family member was able to get it dislodged. However, it has not worked properly since. It sounds odd, idles...

I have given up on aftermarket electric fuel pumps for my 727A zero turn mower. I ordered the JD AM876265 on faith but would like to know the output pressure range which I cannot find in any of the ads/pubs. Anyone out there know the specs?

Were is this device located?

Greetings to all... Perfect operation for all these years of my well maintained 1991 JD 332 diesel. Past summer the engine was stopping with the fuel solenoid turning it off. After 2-3 hours or after overnight, I could restart the engine but after 10-15 minutes the fuel solenoid would stop the...

I just acquired a John Deere JS25 walk behind Momentum mower. It is a project mower. The Quantum engine seems ok. So Far. The two under deck baffles are in tough shape. I looked up the part numbers and they are no longer available. GX22930 and GX21066. The mower deck reminds me of a...

Evening, Does anyone have some real world experience on how long the Hydro-gears last? Both machines have the sealed Hydro-gear and very much in the residential camp. - I have a JD z235 that has 120hours on it, well taken care of. - I just picked up a JD z345m with 28 hours on it for a deal...

Does anyone know what part number this is? It mounts on top of the lift arm brackets to prevent the bracket from slamming into the mower frame. I call it a bump stop. I don't know what John Deere calls it. I have had exactly zero luck finding it online.

Please contact me if you have one to sell. I am hihgly motivated and can arrange for shipping. Please email me at shaaz@smbb.com Thank you.