hydrostatic

Anyo had any luck draining a Hustler Raptor sealed hydrostatic transmission. I know they're supposed to be sealed and never need the transmission oil changed but oil breaks down over time and use.

Trying to suck the oil out through the fill hole using an oil syringe with 1/4 if hose. Only been able to get 22oz out seems to be no way to get the hose deeper in the unit. Any advice would be appreciated.

Trying to remove the Drive wheel using puller and mallet, it did come off but axle came off too. Axle is back on and secure but need to refill fluid. Question is how much and what type?

I have owned this lawn tractor since August 29, 2001. I personally haven't serviced, what the manual refers to as "Adjusting Brakes (Gear)". The manual has 3 types of brake adjustments Adjusting Brakes (Gear), Adjusting Brakes (Automatic Hand Control) and Adjusting Brakes (Automatic Foot...

My troy bilt horse xp hydrostatic 46" cut riding mower will start and the engine runs fine. The blades will engage and operate correctly when engage the PTO. But it will not move forward or backwards when try to put it in gear. What do I need to do to get it to work and drive?

Is there a maintenance schedule for the transmission? I've had the same mower for over 20 years and if there's fluid in the transmission, I'm thinking it could be due for a fresh refill. Also, exactly how would I drain and refill the fluid(s). Also, has anyone discovered a way to replace the...

I hope this is the place to ask this question. It's a bit open ended. While mowing his lawn, my father in law heard a clunk and noticed that what appeared to oil was coming from the bottom/back of his mower. It's a Husqvarna MZT-61 with a 27hp Briggs engine. My question is two part. 1. With...

Looking for a repair manual or video on removing the transmission. Any help would be appreciated. M

hello all, i have an older simplicity broadmoor with 16hp kohler, and 44 inch deck. i have a "test hill" on my property that i use to test riders. its almost a 45 degree incline. everyone of my riders i buy or sell, gets on this hill... most climb right up, some spin the wheels... THIS...

My honda536 when I start mower the blades are spinning before I engage yellow button.any ideas what this could be.

Been trying to change the oil in a sealed Hustler Raptor hydrostatic transmission. I'm using a oil suction pump but can only get 22 oz out. I'm using a 1/4 hose but can't seem to get it pushed lower into the unit. I'm going thru the fill port. Any ideas on what else I can try? 2017 raptor 52 inc

When I start my honda536 the blades are spinning before I engage the yellow button and pull back bar mower cuts lovely the speed control works fine but every time I need to empty box I have to stop mower as blades running at all times.any ideas?