hustler

Hello all, I have a Hustler mini FasTrak 42" with a Honda GXV530 twin that I bought new 20 years ago. I started having trouble with the starter last year. Had to bang on it to get it to work. I finally installed a new starter and solenoid combo. Now when I try to start it keeps blowing fuses...

I have a Hustler 927806 with a Kohler CV740 engine. I bought this mower used and have been restoring it and now that I have it running, there is a problem with it running rough under load. It runs fine with full throttle and no load, but if I put some load on it such as blades engaged and going...

Good morning folks. I recently purchased a hustler 4500. A bit over 2000 hours, original owner and it appears pretty much original very well-maintained. It is my dream machine To be used at my personal property. I’ve run these from my employer off and on for over 30 years. My question is what...

is there a way to convert my hustler raptor to a multching mower or are there better blades that will slow down plugging with the discharge

I've got a hustler fastrac, model 928520, with a Honda gxv610 engine, unsure of hp. I was having issues with it not starting which eventually wound up being a bad wire going to the solenoid. Wife's uncle tore it apart to diagnose but passed away before it got repaired. Now I've got it put back...

Only sometimes. Always when it's least convenient. I've checked all the safety interlock switches (seat is bypassed by the previous owner, so just the arms and blade switch) and all are testing fine. Battery is fully charged. When I turn the key, I hear the click as it powers up. I can hear the...

I recently bought a new hustler raptor xdx and immediately noticed that one tire is much closer to the frame than the other. It’s a full inch closer. I jacked it up. No excessive play. I rolled it in neutral and it’s uniform. Should I be concerned? Couldn’t add photos because files are too...

I recently bought a new hustler raptor xdx and immediately noticed that one tire is much closer to the frame than the other. It’s a full inch closer. I jacked it up. No excessive play. I rolled it in neutral and it’s uniform. Should I be concerned? Couldn’t add photos because files are too...

I have a Hustler 927806 with a Kohler CV740 engine. I bought this mower used and have been restoring it and now that I have it running, there is a problem with it running rough under load. It runs fine with full throttle and no load, but if I put some load on it such as blades engaged and going...

I have a Hustler Zero Turn with about 1500 hours on it and recently the Honda engine has been leaking some oil from the bottom in the area of the vertical shaft. I tried to include a photo, but apparently "it's too large to process". In any event, I am assuming a seal or gasket has failed...