gas

Is it really worth the extra price (Over a dollar a gallon extra) to get ethanol free fuel for mowers? I have a 18 hp Briggs & Stratton engine engine on my riding mower, I have a small small push mower and I have a 2-cycle weedeater. I’m in south Alabama, 65 miles from the coast. The past...

Runs not the best at full throttle but good enough ti get the job done, at idle it seems to run out of gas until the governor kicks in and keeps repeating. Is this carb adjustable?

To skip his skit, click on about the 4 minute mark.

We have had a recurring issue with a Scag 48 with a Kawasaki fs548v engine. Twice it has started to run rough and died. Gas was 3 or 4 inches up in the dipstick and fuel was leaking out of the muffler. Took carb apart and cleaned thinking needle was stuck. Did an oil change and it was fine...

I have a Husqvarna mower with an INTEK 540 cc 18.5 hp engine. I changed the oil, oil filter, fuel filter, air filter 2 weeks ago, then ran it for 90 min cutting part of my lawn. Went back a week later to cut the rest and the mower started but blew out clouds of white smoke and spit oil out of...

I've got a 5 gallon can (with 3 gallons) with very old gas, maybe 3 or 4 years. Never could figure out what to do with it.. as in..how to get rid of it. Any suggestions. ?

My Poulan Pro Riding Mower - PP20VA46 is leaking gas. When I start it, gasoline comes streaming out from the exhaust, it looks like. This is after sitting for a few of days. The gas tank was full the last time I used it a few days prior. There was only a little less than 1/4 left in the tank...

I went to checked the oil in a Kohler sh265 engine and gas poured out when I took the cap off. Any idea what happened? Thanks, Joe C.

Question: My Scag Liberty, now 3 years old. & Last week mow, gas gauge read about 7/8 FULL of gas Before I mowed for 48 minutes, then cleaned & parked. After the mow, I checked gas gauge it is now reading FULL of gas. None has been added. & parked in same spot in garage.. Same temps etc...

Trying to add a gas tank from my older Briggs motor (Model 217802) onto a new Briggs E1150 engine that came without a fuel tank attached. Any help with how to mount the bracket that attaches to the tank from the old motor to the new one would be appreciated.

i have a hustler raptor with a kohler 7000 series engine..in my air filter housing i can smell gas..the filter looks like gas has got on it too..im trying to determine if this is a carb problem which i am thinking it is or something else..the mower runs fine and does not smoke..any help will be...

We have had a recurring issue with a Scag 48 with a Kawasaki fs548v engine. Twice it has started to run rough and died. Gas was 3 or 4 inches up in the dipstick and fuel was leaking out of the muffler. Took carb apart and cleaned thinking needle was stuck. Did an oil change and it was fine...

I have a B&S Quantum XTS 50 serial 12F802-3112-B1 It won't pull start on gas. Replaced the primer bulb and checked it works. The air cleaner assembly MAY be warped and I will replace that next, I understand that can affect starting but should not affect running. (edit: the primer bulb does not...

Gas tank is leaking right at the gas line connection. I have replaced the grommet four times using grommets from different suppliers (they all look the same) but still get a steady drip. I even tried using a bolt-on wheel valve stem with the valve removed. That works better, but I still have a...

Tried to start engine and gas is leaking from underneath muffler

I purchased a Garden Way Mini Tiller at an Estate Sale. It had not run in years. The Tag on the Engine shroud says 8079 so I assume one of those numbers is the year? I should have never fixed it because it needed a Carburetor, Coil and Axle bearings for the Transmission. I rebuilt the Carb...

i changed my oil and when i went to take the oil filter off it seemed like there was a little gas in the filter..the mower runs good with no smoke..i have a possible stuck float needle or could it possibly be the fuel pump..im trying to get the money to get it looked at but cant right now..just...

HRX with GCV 200 is spewing gas out the air filter area and the gas is bubbling after running. I believe it may be a pressure build up. I’ve replaced the gas cap last summer due to it leaking gas out the cap. Anyone have any suggestions?

I have a b&s model 93502 Type: 0200-01 Code: 82011501 This is on an old snapper that i used for years until the gas tank got a hairline crack and was put under my building for 25+ years. I’m wanting to replace the carburetor & fuel tank with one of these...