crank

Purchased a Toro Bronco new 15 years (or more) ago and it has had a very babied life at a lakehouse that only gets used about 3 times a year. I had a need to loan it to son-in-law that burned up ( it literally caught on fire ) his new JD Zero turn. Never had any issues at all with the Toro /...

The engine just stopped, it will not crank!! nothing no clicking nothing, I did not hit anything. had to push it to the shed now what. It has fuel I checked the volts the other day when it was running had 13V. Is there a cut out for the oil level?? I thought I checked it before starting and it...

Scag STT52A-CH25 has been starting for months after several attempts turning key to start. Now I can't get it to start without jumping the solenoid. I've replaced the ignition switch, ign. relay, and solenoid. I get full (12.8V) battery voltage, with key on start position, on green/white wire...

Just pulled down and rebuilt a non-working 10hp BnS. Runs like a dream now but, there's oil leaking from the crankcase gasket...which I replaced. Does that mean the engine is a bit warped? Obviously have to pull it off again, but what am I looking for? Any advice or suggestions greatly...

Going to be working on a Red Max EBZ7500 (a.k.a. Husqvarna) blower. Is it possible to remove the crank seals without splitting case and removing the crank?

Hi All, Mower Info: Snapper Pro S200XT Professional, Model # 5901280. Engine Model Number: Briggs & Stratton 49T877-0010-G1 Quick Summary: Last year I changed the PTO switch because it had gotten loose. Later in 2023, the PTO clutch locked up and I had to have the repair shop replace it...

Turf Tiger Model STR61V-26DFI SERIAL K2000422 No crank with key switch. Have replaced key switch, PTO switch, relay, control module under warranty TWICE. Cleaned all connectors and checked all safety switches and fuses. Will run for a while then no crank at key. Once ran fine for a couple years...

Only sometimes. Always when it's least convenient. I've checked all the safety interlock switches (seat is bypassed by the previous owner, so just the arms and blade switch) and all are testing fine. Battery is fully charged. When I turn the key, I hear the click as it powers up. I can hear the...

Unit #1 Model 31A607 Type 0741-E1 Code 070326ZE I/C 15.5HP Unit #2 Model 287707 Type 1224-E1 Code 971009ZO I/C 14.5HP I do not believe either of these units have an ignition safety interlock issue since both solenoids always activate. Both units have had their batteries swapped...

Here’s something to check when you turn ignition to start and only get a click. Reach under each control arm and push up the plunger on the safety switch and then try to start the engine. My Raptor XDX’s safety switch plunger on the left control arm wasn’t being pushed in far enough to activate...