Search results

Have a MS171 bought in 2012 and has never been serviced. It just started leaking gas when put on its side (see pic). I noticed it starts to leak when the fuel rises to a small black nipple (see pic with red circle). If you tilt the chainsaw to submerge the nipple it leaks. Stops once the nipple...

Worked fine when it was put away last season. Blade spins but will not move forward. Has anyone seen this before?

Tractor has 580 hours on it. Replaced the original belt with an 8TEN Belt 810-CBL2440T (57" x 1/2") belt and have about the same slippage. Took the tensioner pulley off and the bearing pulley still feel tight. However I noticed about 1/2" of up and down play in the tensioner arm and lots of wear...

Just replaced the carb on my Yardman (Cub Cadet) RZT-50. Original carb was running VERY rich and engine was hard to start. Repaired it once and did not feel like fixing it again. Installed new carb, gaskets on both sides of carb, and fuel filter. Gas is new. Idle is perfect but off idle to full...

YardMan ran perfect last week. Parked it after cutting. Started it up today and it is running bad. Lots of engine missing sounds and unburnt gas. Sounds to me like a stuck choke. Have very limited experience diagnosing and repairing lawn equipment but do have adequate experience with auto/truck...

Have a 2010 Yardman (Cub Cadet) RZT-50 with the Kohler SV715 motor. I do not see any amperage output for the motor on any downloaded files on the internet. I have seen the CC RZT-50 with lights on the front so I would think there must be some amperage available to run a pump. Just got the...