Search results

how do you check the pushrods?

Yes, there is fuel to the carb and the float/valve are working properly

This mower was turned in to me after the engine shutting off slowly while driving (as if it had run out of fuel). Brought it in the shop and checked oil, spark plugs (tested both plugs in both coils), air filter, fuel filter, fuel pump, and the electronic carburetor shut-off pin. All were...

Where do you get the fuse blocks for Exmarks? I called my dealer, and he said I would have to buy the whole wire harness, but I don't want to pay $200 for a piece of plastic haha.

Finally found the problem with this mower. all it turned out to be was that the wires going into the fuse block were a little loose.

Okay so I retested this and found that the guy I had helping me had his probe on the negative terminal while I tested the voltages at the key switch. Here are the correct voltages for the A, I, and R terminals. A: off - 12.5v on - 10.5v run - 12.5v I: off - 12.5v on -10.7v run - 10.7v R: off -...

The "B" voltage is the same as the "I" and "R" voltage. While testing this though, when I turned the key to "run" i got a faint "click click" from the mower, but it only happened once. I tried turning the key 4 or 5 more times and it didn't happen again.

Terminal A key in off position: 0v key in on position: 2.2v key in run position: 0v Terminal I key in off position: 0v key in on and run position: 2v Terminal R key in off position: 0v key in on and run position: 2v

This is what I thought at first, but normally, the screen will still have something displayed. I have 2 other Exmarks, so i went out and tested them, leaving one of the safety switches off each time to see if i could narrow it down that way, but the screen never completely went blank. Would this...

Yes, I tried this in hopes that it would be such an easy fix, but the battery tested fine

New member here looking for any help I can get. I tested the battery, key switch, starter/solenoid, and fuses on this mower, and all are perfectly fine. When you turn the key switch to "on" the display screen goes blank and none of the safety switch indicators even show up on the display...