Search results

Hey Folks, I'm back to working on my Tiger Cub I rebuilt last summer. I posted questions in September about rewiring because of PO rigged the wired and did away with all safety switches. I'm still trying to figure out how the safeties all work through the harness. Today's question is ...does...

I have a 2018 Tiger Cat 2 with brake pads worn down. I've pulled the wheel and looked. I see no way to replace just the pads. They seem to be riveted on. Do you have to replace calipers to get new pads ?

I've rebuilt a 2002 Scag Tiger Cub that I had originally bought for parts. I have it to 'like new' condition with lots of sweat involved. The only issue I have now is a butchered wiring harness that I had wired just to get the engine to run. I've toned the harness following the wiring diagram...

My friend asked me to help figure out his Scag quit mowing. After looking at the clutch, it was obvious. The bolt holding the clutch on the crankshaft was gone and clutch had slid down off the key. We looked all over the yard, no bolt found. What are the chances it just backed out ? Or stripped...

I have been pulling my hair out over this 'overheating' (?) John Deere. It has a Kawasaki 600V-as21 engine and will shut down usually after 15-30 min. mowing. My first thought was coils. I bought new Kawi coils. same result. I removed anti-backfire solenoid. same result. I replaced spark plugs...

I bought this '02 Scag for parts then, unfortunately, decided to restore it. It had a replacement engine (CV23) on it with breather separator missing from valve cover. Being it was sitting out in the weather, PO stated it was full of water. I tore down the engine and surprised there was no...

I've purchased a Scag Tiger Cub with 1200+ hours with a blown engine. I decided to take on the project of a complete engine rebuild. I cleaned up the block that had 2 broke piston rods and galled crank shaft journal. I took the housing to a local machinist who measured the cylinder diameter and...