Search results

I just finished reverse engineering the wiring diagram for the subject mower, it is attached. The A inside a circle denotes the four position connector.

This is a TVM140-70416M engine on a snapper type 10 mower on a just recently inherited non-runner. It has the Type 1 carbeurator. I changed the plug and it would start, but it wouldn't run under high-ish load. I disassembled, cleaned, then reassembled the carb. I have a rebuild kit in hand...

I'm new to this engine, it is 15 years old and just recently came into the family as a basket case. It was running pretty good for a few days but started surging badly yesterday after I repaired the muffler. I somehow knocked the governed idle screw off! Amazingly, the engine started and...

Can anyone recommend a good supplier for parts if I want fabricate an exhaust manifold and/or muffler? I have an older Intek and these parts new are prohibitively expensive (probably more than the mower is worth).

Hi, This is a new engine for me, a family member inherited a non-runner (no spark). I'm looking for the skinny on this engine: Are there any external timing marks I can check? Does it have the so-called compression release that limits valve closure at starting? Is it prone to jump timing? - I...