Search results

The belt slips off the left idler pulley when engaging blades. The keepers are about 1/8-1/4” from the belt. All pulleys spin freely. I notice the idler pulley is angled down toward the front of the deck.. is that normal? Have a look at the photos… any ideas?

I'm changing the fluid and cleaning the filter in my K46C transaxle. The shock damper stab o shoc 5868eb 0000n 141/01 A3 is leaking fluid and needs replacing, but I can't find a replacement. Does anyone know what this shock damper can be replaced with? I also have a K46C plastic fan with 2...

The 38" deck on my H2013 caused the tractor to stall. I removed the deck and found the blade shafts were hard to turn, probably bad bearings. I notice there are two bearings for each blade shaft, an upper and lower... Why are there two different part numbers for bearing that seem to have the...

Hi All, I am running a Craftsman (MTD) 8hp chipper/shredder, probably 20+yrs old. It runs fine but I'm looking to upgrade. Can anyone tell me about the Troy-Bilt 47321 Chippewa style 10hp chipper/shredder, including when it was made and how it compares with the Craftsman I have, and how it...

I have an older Briggs 5hp motor with a starter clutch that is missing the ball bearings. The Briggs part# for these is 691604. My question is can a "standard" non-Briggs bearing be used, and if so, what size (diameter) is the bearing. Thanks for the help, Al.C

Hello all, After changing the belt on my 2013 mower deck I noticed very little tension on the belt. Checking a diagram, the tension pulley spring was missing. I ordered a new spring, but find it very difficult to install due the strength of the spring. I started to flex the blade of a large...

I have a Honda h2013 and would like to convert it to run on gas or propane. If you have done this conversion please let me know how you accomplished it. I have a Garrett regulator which will meter fuel based on engine vacuum, my weak point is where to connect the fuel line from the regulator...

Hi all, I have an older H2013 with a seat that has no outer covering, just the interior foam. Replacements seem expensive, but a good condition seat with mounting for a Honda 3810 tractor is available... question is will it fit? Thanks for any help, Al