Search results

Results 1 to 3 of 3
  1. C

    Command cv16s Not charging

    I did an engine swap on my cub cadet, a bought a cv16s at the time of buying I didnt know that It had an unregulated 3 amp charging coil unlike the 15 amp cv16. I needed a 15 amp so I bought a cv16 flywheel and cv16 stator. I bought a used flywheel but an Amazon stator and regulator. Everything...
  2. C

    Briggs 14hp IC not running right

    Hi all, I have a Briggs 14hp ic I just swapped on a mower, carb was junk and unrepairable unfortunately had to get a Chinese one. Anyways the motor won’t rev past 2300 rpm and has very poor throttle response, if you put it to idle then wide open, it just falls on its face until it finally picks...
  3. C

    LT 1018 Pulley stuck on motors shaft

    Motor blew up. Have to take engine apart but my drive pulley will not come off the motors shaf. i heated it up for 10-15 minutes with a blow torch and I'm using a puller and no luck. Also using lube. i am bending the pulley but at this point i dont care i can buy i new one. any tips or help...
Top