Search results

I have replaced Variable Pulley bearings.....Variable speed pulley is free, not bound up. Idler pulley is free, not bound up. Upper belt replaced (MTD OEM) , Lower belt replaced (MTD OEM). I am having problems with the speeds on the transmission. It seems it only wants to give me one speed. I...

Buying a new deck for my Toro Timecutter 4235 and they are not cheap. I did my best efforts to keep it clean and grass free, and never cut wet grass, but alas, 5 years later, the deck is literally rusting apart. So whats the general consensus on pretreatment before I install the new one. I'm...

I have a OHV Single cylinder 17.5 B&S engine that exhibited classic signs of camshaft compression release failure...engine would bump 1/4 of a turn on attempting to start. When I opened the engine, the camshaft and compression release device was intact. No visible signs of undue wear on...

Honda Pressure wash engines start up fine, create advertised pressure and then just quit. They will start up again. I have checked the gas caps and they are venting. They will restart but will shut down again within 5 to 6 minutes. Both are doing the same thing. Any thoughts? one is a GX one is...

i have two pressure washers with GCV-160 engines. They both pump fine, when the engines running. They both start up easily,run for a while then just shut off. I've drain tanks and checked for fuel flow. I have checked the caps to ensure the gas cap vents are clear. The carburators have been...

Selling. $150 plus shipping. I have this listed on Ebay also and Facebook Market place.. good operating condition 6 speed. with pulley