Search results

A friend dropped off an ETQ TG-3600 he found at the curb and asked if I could get it running. Tank and carb were full of water so I cleaned everything up and generator surges no matter what I've tried. It surges on idle and under load. Here's whats been done. gen model ETQ TG-3600 engine...

I'm looking for the manual the goes with an older ETQ generator. I've looked high and low and have come up empty. ETQ TG3600 Thank to all who reply

Need some help troubleshooting a briggs plastic carb model 799584 mower model 09P702-0145-F1 Mower runs erratically and will die under load and can't be restated unless the carb is pulled and cleaned. Runs and dies with carb spray. I've had the carb apart multiple times and can't figure out what...

I have a small non inverter generator with a battery tray that is an oddball size. I'd like to weld on a new one. Will welding on the frame damage the electronics, AVR etc. I've heard a few different answers and was wondering if there is any definitive advice. FYI its a 7 HP Honda clone. Thanks...

I'm thinking about trying something new, at least for me, storing my 4 cycle equipment. I plan on draining my float bowls via main bowel nut or drain nut then generously spraying WD-40 up into it. Was wondering if there is any problem with leaving WD-40 in a carb long term. Thanks to all who reply.

The carb is a walbro WYL 280 009. The needle has a viton tip and the carb has a metal seat. I believe the kit should be k20-wyl but the needles seem to lack the rubber tip. Does walbro make a kit for this carb with the viton tip? I'd really hate to spend $10 on the gaskets and another 10+ just...

I just rescued a newer Briggs that was headed for scrap due to a carb issue. When I tipped the mower to change the oil, some gas escaped from the top of the tank where a little fitting?? has been snapped off. I've seen this type of tank before but never with the little fitting. It goes into the...

Hello all..longtime lurker first time poster. I have an old Briggs Quattro 4hp L-head that is ripping the recoil cord out of my hand. This mower had its blade come off at speed before it was stowed for some years. I expected a sheared flywheel key. Key Looks perfect. I checked to see if the...