Search results

I just started using an eXmak 36 inch Metro and I was wondering how to lower the blades a quarter or half inch and if it is a big deal ? I can see the blade shafts are exposed, stick up through the pulley cover plate and looks like they have washers under the nuts.

We live in the NY state area ( southern near NJ ) and I was wondering what would be the best height to cut the grass. We do not have an irrigation system and the eXmark is currently adjusted to a 3 1/2 inch cut height, is this a good height ? Also, the 36 inch deck has about an 1/8 of an inch...

Brand new belts on a 2005 Metro 36 inch mower an done of the wheel drive belts wanders off center and ends up to the side of the two pulleys ? It appears there is not adjustments on the pulley assembly, so how would I resolve this issue ? Thanks Rick

Have a 2005 Metro 36 inch and I just changed the drive belts. One side does not want to stay centered, in the groove so I would guess that something is slightly out of alignment ? I do not see where there are any adjustments, looks like just direct bolt holes. Any advice ? Thanks, Rick

I have a Metro 36 inch that is about 7 years old, it runs fine and all of the drive gears work except for Reverse. Could it be low hydraulic fluid ?

I have a 36 inch eXmark Metro and the rubber stone guard, that hangs from the rear tire axle is shot and needs to be repaved. It is just a piece of rubber that is strapped to the axle with a simple banding strap and two bolts. I can find every other piece and bolt for the mower, however I...

I need to buy a complete set of wrenches and I see that the ratchet type are very desirable, but expensive, probably double the price as a standard wrench. I do not use the tool stat often, so should I just go with the standard Craftsman box & open end instead of the ratcheting type ? Thnaks

I was just wondering what is the best way to access a deck to scrape and clean it ? I was thinking of auto ramps, is there a better way without breaking the bank ?

I was just given this mower to use for the season and I notice the front of the deck has a slight slope down from the back of the deck/machine. Some one had told me it should have a slight slope towards the front because it works better at discharging the cut grass. I would have thought the...

The engine is leaking oil under the carb & muffler assembly and I cannot see where it is leaking from. On the attached diagram, part # 92049B is called the oil seal. I am thinking it is that ??? Also, I cannot see what that attaches to, do I need to remove the engine to replace that part ...

The mower is leaking oil when it is not running so I am thinking it could be the crankcase gasket ??

It appears the Kawasaki 15 hp engine is leaking what appears to be gas even thou the gas valve is closed so I would imagine it is leaking from one of the carburetors ? I guess I need to remove the air filter assembly in order to be able to view the issue ? Any advice would be greatly...

I was just given ( actually loaned ) an older eXmark, a 2005 with a Kawasaki 15hp V engine. It runs fine but after using it the engine leaked fluid that appears to a gas oil combination. I immediately changed the oil and it appeared to be half gas ? After filling with oil the mower ran fine...

I was just given ( actually loaned ) an older eXmark, a 2005 with a Kawasaki 15hp V engine. It runs fine but after using it the engine leaked fluid that appears to a gas oil combination. I immediately changed the oil and it appeared to be half gas ? After filling with oil the mower ran fine...

I would imagine this is a difficult question to answer without considering the specific terrain ( so I think ) however I am curious to know if a floating or fixed deck does a better job of cutting grass, as far as the appearance of the finished cut ? I have a 1/2 acre and I would describe it as...