Search results

Good morning. I'm happy to report that I installed the new choke return spring and adjusted the throttle cable and the choke closes normally when the start lever is in the choke position. Comparing the old spring to the replacement it was obvious the old spring had lost its tension and the part...

LOL! I do have a lot of room for them! ctg

Thanks for the videos they were interesting. I should get the new choke return spring today and I'll take a look to see if it needs additional cleaning but it was power washed last week after the oil and fuel were drained out. I'll see if I can get a good picture after I get the spring...

I'll take another look at the choke position but at first it looked okay to me. ctg

It has a choke. It looks like what I have. The large plastic part on the left is external to the carb. The long end of the spring connects to a notch at the bottom of the wide end. You can see a little protrusion there. It's a notch in the plastic. The coil end of the spring connects to the...

The choke and shaft are free with the spring (618) removed. The new springs (I ordered 2) should be here 7/13/22. I'll try it again. The mower was drained of oil and gas last week and power washed. It's pretty clean. Yeah, this things amazing when it runs. Usually starts up on the second pull...

I found a picture of the choke shaft and spring. This is what's on my machine.

There are two levers on the handle of the mower. The gearshift handle and the throttle handle. To start with, I removed the spring. It appeared that the coils of the spring was rubbing against this plastic piece on the choke shaft. (I'll see if I can take a picture of the carb and choke). The...

When the lever is placed in the 'choke' mode, the choke does not close all the way. There is a spring that pulls the choke closed. The bottom part of the spring that connects to the choke lever connects to a plastic piece and sits in a notch rather than a hole that the spring wire would go...