Search results

I use an air impact wrench

Sorry, let me explain in more detail, I did disconnect from each coil, when I disconnected from the right coil engine run fine with both cylinders firing, both exhaust pipes were equally hot. I have a degree in electronics and know how to check diodes with an ohm meter and that one was bad...

Thanks again for your help, I disconnected the kill switch and both cylinders are firing and running great. guess I need a new diode harness

Where would the diode be located, could it also be the coil?

Thanks you are right, the left cly. is not getting fire, spark plugs are good, what should I check next, the push rods are good it set them all of them at .005"

Briggs & Stratton 22hp TWIN CLY. BOGS DOWN when loaded, the governor does not speed up the engine, I checked all linkage and made sure the springs were attached and reset the governor which was good, any help please

Does anyone else out there have problems with their Gravely throttle and choke cable assembly? Only two years old and the plastic holder broke, now have to replace the whole assembly, Have anyone ever changed theirs, I have a ZT 50, is it hard to get to?