Search results

Results 1 to 6 of 6
  1. O

    Won’t stray without starting fluid or gas directly into carb

    Owner told me about it. He had been doing it for a while. He had a little thing rigged up to do it quicker than pulling the air cleaner off. (It has 4 thumb screws)
  2. O

    Won’t stray without starting fluid or gas directly into carb

    I will check. It does this when the engine is warm also.
  3. O

    Won’t stray without starting fluid or gas directly into carb

    I just picked up a ride on with a 40777 22hp B&S Intek engine. I was told the starter was bad so I replaced it with one I had. put a battery in and it spun. I put fuel in the tank (previous owner drained it before storing which was nice) and tried to start it. The PO mentioned that he always has...
  4. O

    PTO pully help - trying to find a 1 1/8" pully

    Hello all. I have a YTH 22v46 and the engine stopped working. I tore it down and can't find a single issue, nor could my local small engine shop. So I acquired a new engine, not quite the same. It has a 1 1/8" crank shaft where the old engine only had a 1 inch( Husqvarna 532405472). I am looking...
  5. O

    Intek 22 (44N677) will not do anything but rough idle

    We were mowing the lawn and I disengaged the blades and the engine started surging so I shut it down. It took about two weeks until I could get to it again and it would barely idle, and I thought that it was not getting enough fuel. I flushed all the fuel lines, new fuel filter, new vacuum hose...
Top