Search results

Results 101 to 113 of 113
  1. O

    Tec AV520 no spark

    Check wires at points and condenser to make sure they are not grounding out when cover is put back on after adjusting point gap at full open position at the point plunger. 15-17 thousand should be a good gap. Make sure wires are at correct spot at plastic bushing on point assy.
  2. O

    ZT48 XL Single click when starting

  3. O

    Snowblower vibration

    Does it have a light at the handle controls? If yes maybe flywheel rotor magnets came off flywheel, If flywheel is loose engine won't run good and would damage flywheel key and would jerk pull rope from your hand. If you do look at flywheel check to see is weight is still on it. If engine runs...
  4. O

    Briggs v-twin wont stay running

    Test fuel pump with vac gauge/fuel pressure gauge, remove inlet fuel line and outlet fuel line from fuel pump, should have 1-11/2 psi coming out of pump and about the same going into pump but negative reading. If good check vav hose going to fuel pump is not cracked and tight. If these are good...
  5. O

    Running on 1 cylinder

    What engine is it? Make, hp?
  6. O

    Snowblower vibration

    Need engine model number to help you.
  7. O

    ZT48 XL Single click when starting

    Yes, test battery under load. If test low charge and retest. If still low voltage at battery replace it with correct battery. Now you still might still get a click sound but you know you have a good battery. Check for good clean grounds. If still clicks you have a broken wire harness end not...
  8. O

    B&S 10/12HP throttle repair

    I can send you a pic of the linkage installed correctly on 2/3/25. Sorry I don't know how to send online but can text the pic or possible part numbers that will work.
  9. O

    Predator 9500 Generator backfires like a shotgun on shutdown

    Turn gas valve off. Remove solenoid, jump solenoid wires with 12 volt battery. Battery can be from a riding mower, or any 12 volt system, just ground 1 wire, does not matter witch wire, then tap other jumped wire to other solenoid wire. should move about 3/8 to 1/2 inch. If no movement replace...
  10. O

    Troy Bilt Bronco Brakes

    You should check the 2 small push pins behind the arm that is actuating the outside brake pad. Inner pad does not move when pedal is pushed down. These pins rust in the caliper and can't push pad against the rotor.
  11. O

    Please help me find this part!

    That is just a vent hose and will not keep engine from running. You have some other problem. Give me more info and I can tell you what to do next.
  12. O

    Kohler Courage 20---what beside main crank seal will quickly dump all oil from under engine?

  13. O

    Intek 40 Series Pushrod Length vs Adjustment Range

Back
Top