Starter was clicking when key turned, checked battery (12.8V), found bad positive cable. Removed starter, bench test (good), repaired positive cable, put everything back together. Turned key, no beep tone, nothing. Checked battery voltage at 12.7, voltage on starter at 12.7, looked over everything I worked on and it was all in place. I’m thinking key switch, not sure how to validate key switch other than poking around with an Ohmmeter, any suggestions? Thanks in advance, DocHogan
2011 Silver Eagle 2750 No Power
- Thread starter DocHogan
- Start date
mechanic mark
Lawn Pro
- Joined
- Jul 15, 2013
- Threads
- 175
- Messages
- 7,479
Check negative ground cables for being loose.I would also remove battery & take to auto parts store for load test at no cost to you.
Page 41 is the wiring diagram.
Yes sir, wires are correct, fuses looked good, and it is 27hp Generac & thank you for the wiring diagram too!
Yes sir, the 2 grounds I’m aware of are both secure. I did a load test on battery which was a bit low and replaced to be safe…new battery did not help
.