woodstover's latest activity

Yeah except they are referencing the part # in description

As the saying goes... they say, "it fits", but that does not mean it works.

Hi there, working on neighbour's Self Propelled Lawnboy. The cogged belt was broken and the drive belt is worn & cracked. We ordered...

That is true if you use RTV on most formulas, not all. Read the directions on any sealant. Just to throw out another benefit...

Have you tried the steering shaft kit? PN 587738904

I heard guys say to finger tighten the RTV down and wait 24 hours before torquing it.

Trick is a non hardening sealant. This stuff is great if YOU are the guy removing the cover next time. For valve covers and oil pans...

I apply gasket sealer to a clean valve cover flange, next apply the gasket, pin it down to a flat surface overnight, next day when...

Buy or make your own cork/neoprene gaskets, they will be reusable at least once if you don't overtighten the valve cover. I would use...

Check the valves yearly for a good runner. Only takes about 3 minutes. I don't use RTV that's why so fast. RTV used you will be out...

Hello S, It is not a matter of waiting until you hear any noise or experience a breakdown. The valve adjustment is to keep the engine...

I have had several over the years that you couldn't tighten the drain due to the flats hitting the frame below the engine. Have to...

There's a notch in the plastic that catches on a small bump on the metal part of it, but it's easily pulled over it.

There is no hard stop to prevent pulling the thing apart again. And you will be tightening the threaded portion everytime you service...

The plastic piece just has 2 o-rings internally that seal the oil in, when you pull it forward the Orings no longer block the drain...