woodstover's latest activity
-
Heads up on this one as the installation snap ring is wrong. Does not fit even if you open the ends enough. I am lucky to have saved the... -
Update time, I was looking thru the circuit again. Noticed that there was a buildup of dirt/grass on the connector to the key switch...
-
-
woodstover reacted to the.doc's post in the thread Craftsman 900.370510 emits rhythmic noise with
Like.
I took the cover off, which wasn't easy, and found an unbelievable amount of dirt that had collected inside. About a half hour with a... -
woodstover reacted to StarTech's post in the thread Craftsman 900.370510 emits rhythmic noise with Like.
this mower runs household AC so no battery.
-
woodstover reacted to Tiger Small Engine's post in the thread Convert Ryobi RM300e to Lithium battery with Like.
A potential firebomb in your garage. I would store it outside under cover away from your house.
-
woodstover reacted to Auto Doc's's post in the thread Craftman 5000 Watt Generator hard Starting when Hot with Like.
One thing that comes to mind is fuel percolation in the fuel bowl after shutdown. All that post-shutdown engine heat directly effects...
-
woodstover reacted to Auto Doc's's post in the thread Craftman 5000 Watt Generator hard Starting when Hot with Like.
If it has a low oil switch at the bottom, on the side of the block, unplug it and see if it will start when hot. These switches were...
-
woodstover reacted to Rivets's post in the thread Still trying to get the mower deck right with Like.
Here is the reassembly order I suggest you follow. 1. Admit that I’m smarter than those on this forum who have tried to help me. This...
-
woodstover reacted to farmerdave1954's post in the thread Still trying to get the mower deck right with Like.
Holy cow! I can't believe I just sat here and read through all 9 pages of this thread going back over a week! JimP2014, I do believe...
-
woodstover reacted to MParr's post in the thread Still trying to get the mower deck right with Like.
I've already suggested that he "call the man." Other than that, I'm done.
-
woodstover reacted to Rivets's post in the thread Still trying to get the mower deck right with Like.
Not you for sure. I don’t know why I keep following this thread, but it has gotten so bad I have to warn others not to use anything you...
-
woodstover reacted to MParr's post in the thread Still trying to get the mower deck right with Like.
The only ways that pulley could be tilted is a bent bolt, wallowed out bolt mounting hole or bent mounting bracket. THE END!
-
@GearHead36 I don't know if it was a proven fact or some word of mouth that spread about, with the original reason being trying to...
-
You’ve posted 2 threads with the same problem and have done what experienced techs never do, THROW PARTS AT IT TO SEE WHAT STICKS. As...