woodstover's latest activity
-
woodstover reacted to Snapper series 6 1987's post in the thread Snapper series 6 Briggs model 191707 type 251501 Having trouble removing drive pulley . with
Like.
I did see some of Jim's videos and quite a few others. I did find a Briggs manual and got a few ideas from that as well. It just took a... -
woodstover reacted to Snapper series 6 1987's post in the thread Snapper series 6 Briggs model 191707 type 251501 Having trouble removing drive pulley . with Like.
Again, thank you to everyone. I wound up having to use wax, wd40, ATF, Blaster, propane, 3 lb mall, soaking over night several times...
-
woodstover reacted to ILENGINE's post in the thread This is the stuff that makes small shops look bad with Like.
Here is the correct plug for comparison Notice the thread length difference and the washer instead of the tapered seal
-
maybe. Or dirty air cleaner, or old fuel, or worn rings
-
woodstover reacted to farmerdave1954's post in the thread Won't Spin Past Compression Stroke with Like.
It's early, and I'm still having my coffee, so I may just be dense this morning, but this doesn't compute. Can you explain the logic...
-
Sorry if this has already been said, but you have compression issue trying readjusting the valves if that doesn't work you probably have...
-
Adjust the valves if no help then compression release not working.
-
After 18 replies, 3 different starter replacement attempts and jumping with a vehicle battery, the obvious that has been explained is...
-
Very well could be the compression release failed. I would adjust the valves first. Probably never been adjusted since the engine left...
-
Looks like Ohio has 431, NY has 589, NC has 612, TX has 53, and UT has 214, and IA is out of stock but that is PD's version of a...
-
woodstover reacted to Tiger Small Engine's post in the thread Won't Spin Past Compression Stroke with Like.
Step 1). Load test battery and clean and tighten all connections. Step 2). Check valve clearance and adjust as needed. Step 3). Listen...
-
Yes, but the valves need to be properly set within tolerance to make the final decision if the compression release has failed. But...
-
Probably using a car compression tester on a small engine (gives you inaccurate readings) and valves are out of spec. Dynamic...
-
Perform valve adjustment. Load test the battery with a carbon pile tester. I see you sub'd in a car battery with no luck. Points to...
-
woodstover reacted to 1chris1's post in the thread Craftsman LT2000 2013 with Briggs 331977-0008 Intek 540cc engine, carburetor pulsating with Like.
Someone told me to do take the black cap off and clean under there on TractorForum, I didn't understand the whole procedure with the...