Recent content by weedwarrior

I think this is my problem, I should probably get assistance with holding it tight to the block as I am tapping piston into the cylinder. I did break a set of rings, order another pair. More to come.

Update, I filled it in with JB Weld and smoothed it out, didn’t take much. (I heard others use J.B. in the cylinder and as long as the prep was good the weld took and lasted the owners for years after the fix) I did take it apart, washed it out With dawn dish soap, got it real clean and put it...

I can run my nail over it and although my nail feels the grooves it doesnt get hung up on it. I have a feeling the rings would get caught up in it and cause the same problem all over again though. I'm trying to avoid taking completely off the frame and taking it anywhere... also I spent enough...

Usually its the red safety wire behind the rear right tire I believe, it rubs on the frame and shorts out. try looking for that. You will have to take the tire off to fix it.

Weekend warrior semi mechanic- question for anyone. My valve bent and caused my piston to jam up blow into pieces. I have gotten it apart and ordered a new piston with rings and new valves. During the piston Explosion it gauged the cylinder walls in a few places, some came out when honing it but...