Recent content by Tvandame

  1. T

    I replace the carburetor on my HR 215 when I try to start it it only runs on high RPMs

    Igen2000 it surges at idle and at high speed. Have cleaned the low speed ports out still does it. A new car is 196 bucks the ones they sell online for 30 or $41 don’t have the correct plug to plug into the circuitboard for the generator.
  2. T

    I replace the carburetor on my HR 215 when I try to start it it only runs on high RPMs

    Does anyone on here work on Honda generators?
  3. T

    I replace the carburetor on my HR 215 when I try to start it it only runs on high RPMs

    OK I broke down and I bought a carburetor. I reset the static on the governor put it all back together. Started it up runs great. I cannot believe that cleaning a carburetor does that. But I want to thank you guys for all your help. It runs great. I can’t believe $15 fixes it. Again thank you...
  4. T

    I replace the carburetor on my HR 215 when I try to start it it only runs on high RPMs

    The only thing I did was take the carburetor off, remove the throttle, linkage and spring, which are attached to the governor arm and the choke linkage. Nothing was bent that I could tell when removed. Hypothetically, could’ve governor inside the Block be bad?
  5. T

    I replace the carburetor on my HR 215 when I try to start it it only runs on high RPMs

    I don’t know if my reply went through. Last fall when I change the oil and winterized it, it was just surging. The spring I just took the carb off rebuilt it put it back on.
  6. T

    I replace the carburetor on my HR 215 when I try to start it it only runs on high RPMs

    Last year when I change oil and ran the car by the gas, it was surging so I figured the carbon need to be changed or repaired. I pulled it out this year and just pulled the carpet part. Put it back together. Last year it ran at low speed, but it surged a lot. I rebuilt the car cleaned everything...
  7. T

    I replace the carburetor on my HR 215 when I try to start it it only runs on high RPMs

    The linkage only goes in one spot and there is only one hole for the spring.When the engine is at rest and stop, does the throttle go to wide open?
Top